Amp meeter series#

The two wires between the meter and shunt bar need to be the same length. If you connect them to your battery and get a negative reading, simply swap the wires.Ĭalibration: If the needle on your analog meter is not at zero when there isn’t incoming power, you can calibrate the DC meter by turning the screw on the front of the meter. Volt Meters: The positive and negative inputs are typically not marked on the DC Volt Meter. If your meter is over 15 amps, you will need a shunt bar (refer to the wiring diagram above).Īmp Meters: If the needle on the meter is a negative reading, switch the sense wires between the meter and shunt bar. Match the millivolts (mv) of the meter to the millivolt (mv) rating of the shunt bar. Match the amp rating of the meter to the amp rating of the shunt bar. To test the amps or volts of your wind turbine or solar panel system with a handheld clamp-on meter, you must use a DC model.ġ2-volt battery systems should use a 15- volt meter 48-volt systems should use a 70-75 v olt meter. Clamp Meter, Digital, Clamp Meter Jaw Style Clamp On, Max. Featured Product AMPROBE Clamp Meter, LCD, 600 A, 1.4 in (36 mm) Jaw Capacity, Cat III 600V Safety Rating Zoro G9486461 Mfr AMP-320.

Amp meeter series#

The ammeter is usually connected in series with the circuit in which the current is to be measured. Electric currents are measured in Amperes (A), hence the name. 12 Volt battery systems should use a 15 Volt meter 48 Volt systems should use a 70-75 Volt meter.ĭon’t allow incoming power to exceed the rated amperage (or voltage) of your meter – it may break the unit.Ī wind turbine should be connected to a separate meter than the solar panel(s). 320 Amp Meter Base If you need a 320 amp meter base we have them at everyday low prices. An ammeter (abbreviation of Ampere meter) is a measuring instrument used to measure the current in a circuit.These amp clamp meters are designed for noise-free, reliable readings. Don’t allow incoming power to exceed the rated amperage (or voltage) of your meter – it may break the unit The Fluke digital clamp meter is a workhorse tool for everyday use.Make sure to use a DC amp meter for amp readings.To test the amps or volts of your wind turbine or solar panel system with a handheld clamp on meter, you must use a DC model.

Tips & Things to Remember in DC Amp Meter Wiring Choosing a meter